Teletronics WL-CPE-ROUTER Manual de usuario descargar pdf (Pagina 19)

Teletronics International Inc. CPE Complete User Manual

Page 18 of 27

Step 4: Setting up the ether1 adapter. Click on the default IP (192.168.1.1) to

modify it. The default values will appear in the IP, Net Mask, and Comment

fields. Make your modifications, and then click on the Modify button.

After your modification have been made, checks will appear at the right to

indicate weather or not your changes were appropriate. If you have chosen

IPs that are in conflict, you will be notified with "x"s.

Appropriate Modification Inappropriate Modification

• Important Note: Now that you have modified your ether1 adapter, after you click the

Activate button or the Save and Reboot buttons, you must enter the CPE

Configuration Utility through the new IP, in this case, https://192.168.1.2.

Step 5: Setting up the wlan1 adapter. By default, the wlan1 adapter is not setup.

Enter these following values into the following fields:

When you have completed value entries, click the Create button. If there are

no IP conflicts, the software will allow the modifications.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sin comentarios

Teletronics WL-CPE-ROUTER Manual de usuario Pagina 19